Start here · Essential guide
Amplifier and Signal Circuits: Feedback Amplifier Types Explained
Guide to feedback amplifier types: negative vs positive feedback, the four feedback topologies, and how each one changes gain, impedance and stability.
Analog and Signal Circuits
Op amp gain, comparators, amplifier classes, 555 timers, phase-locked loops and analog filters.
Start here · Essential guide
Guide to feedback amplifier types: negative vs positive feedback, the four feedback topologies, and how each one changes gain, impedance and stability.
Comparing 2 and 4 channel oscilloscopes: what extra channels give you, when two is enough, and specs such as bandwidth and sample rate that matter more.
How to calculate frequency and duty cycle for a 555 timer in astable mode, with the formulas, a worked example and practical tips for beginners.
Analog filter design basics: RC cutoff formulas, Sallen-Key active filters, design tools, and common mode chokes in EMI filters, with safety notes.
Class A and class D power amplifier circuits with design values: bias and efficiency for class A, and a PWM stage with filter values for class D.
How a differential amplifier amplifies the difference between two inputs and rejects common-mode noise, with CMRR explained and a worked gain example.
Inverting and non-inverting op amp gain formulas with worked examples: -Rf/Rin, 1 + Rf/R1, the voltage follower, input impedance and real op amp limits.
How op amp comparator circuits detect a voltage threshold: inverting and non-inverting setups, a divider reference, LM393 outputs and when to add hysteresis.
How op amps prepare signals for an ADC: buffering, setting the input range, anti-aliasing filters, and checks to run before you build the board.
Explains what PLL means in electronics and how the 566 voltage-controlled oscillator fits in. Covers the 565 vs 566 difference and building a simple PLL.
How a Schmitt trigger uses two thresholds and hysteresis to clean up noisy signals, with op-amp formulas, a worked example and practical uses.
The four types of feedback connections: voltage-series, voltage-shunt, current-series and current-shunt, and how each changes input and output impedance.
PLL means phase-locked loop in electronics. In cyber security it is not a widely used term, so check the context where you saw it and what it refers to.
A phase-locked loop (PLL) is a feedback circuit that locks an oscillator to a reference. Covers the phase detector, loop filter, VCO and common uses.
An ADC turns a continuous voltage into numbers a microcontroller can read. Covers resolution, sample rate, step size and the common ADC types.
When to use AC or DC coupling on an oscilloscope: DC is the usual default, AC coupling helps with small signals on a DC offset, and its limits.