Analog Circuits

When to use AC vs DC coupling oscilloscope?

When to use AC or DC coupling on an oscilloscope: DC is the usual default, AC coupling helps with small signals on a DC offset, and its limits.

On this page
  1. Short answer
  2. What DC coupling does
  3. What AC coupling does
  4. Example: ripple on a 12 V rail
  5. When AC coupling gets in the way
  6. Quick checklist
  7. Safety note

Short answer

Keep the oscilloscope on DC coupling as your default. Switch to AC coupling when a large DC offset hides a small AC signal you want to see, such as ripple on a power rail. AC coupling blocks the DC part of the signal, so it can distort slow signals and square waves.

What DC coupling does

DC coupling connects the input straight through to the scope’s front end. The trace shows the whole signal, including its DC level, and the AC variation riding on it. Use DC coupling when you need to:

  • Read the true voltage level, for example to check whether a 5 V rail is at 5 V or 4.6 V
  • Look at slow or low-frequency signals
  • Check whether a signal is clipping because of a wrong DC bias
  • View digital logic signals

What AC coupling does

AC coupling places a capacitor in series with the input. The capacitor blocks DC and passes changing signals. Together with the scope’s input impedance, it forms a high-pass filter. Its cutoff frequency is low, usually a few hertz to around 10 Hz on many bench scopes, but this depends on the model. Check your scope’s manual for the exact value.

Example: ripple on a 12 V rail

Suppose a 12 V supply carries 50 mV of ripple at 100 Hz.

  • DC coupling at 2 V/div: the trace sits at 12 V. The 50 mV ripple is only about 0.025 division, which is too small to see clearly.
  • AC coupling at 20 mV/div: the DC is removed from the display, and the 50 mV ripple spans about 2.5 divisions. The 100 Hz ripple is far above the cutoff, so it passes with little change.

The coupling setting is per channel, so you can view a raw signal on one channel and the AC-coupled version on another.

When AC coupling gets in the way

  • Slow signals. Frequencies near or below the cutoff are attenuated or distorted.
  • Square waves. The flat parts can droop or tilt, because the average level is removed. This is a common surprise when a square wave looks wrong.
  • Pulses with long high or low periods. The DC content of the pulse is removed, so its shape changes.
  • Measuring a DC level. AC coupling hides the level you want to read.

If a waveform looks different when you switch coupling, the scope is showing you the effect of the capacitor, not a change in the circuit.

Quick checklist

  1. Start on DC coupling.
  2. If the wanted signal is too small or sits on a large DC offset, switch that channel to AC.
  3. Check that the low-frequency parts of the signal still look right.
  4. Switch back to DC when you need the absolute voltage level.

Safety note

Do not probe mains voltage with an oscilloscope unless the scope and probes are rated for it and you have the training to do it safely. For mains work, use an isolated measurement tool designed for that purpose.

The complete guide to analog circuits

Amplifier and Signal Circuits: Feedback Amplifier Types Explained
Read the guide

Keep exploring

Guides from other topics

All topics →