Start here · Essential guide
Types of Electric Motors: DC, Servo and Stepper Compared
Compare DC, brushless, servo and stepper motors for hobby projects: how each works, how servo and stepper differ, and whether a DC motor is an actuator.
Power and Motors
DC, brushless, servo and stepper motors, with wiring, speed control and driver circuits.
Start here · Essential guide
Compare DC, brushless, servo and stepper motors for hobby projects: how each works, how servo and stepper differ, and whether a DC motor is an actuator.
How brushless DC (BLDC) motors work: permanent magnet rotors, three-phase windings, Hall sensors versus sensorless control, and why an ESC is needed.
What KV means on a brushless motor, how turn count changes KV and torque, how to estimate speed from voltage, and how to pick a KV for your build.
How PWM controls DC motor speed: duty cycle, a MOSFET switch, a flyback diode, and the equivalent circuit that explains why speed follows voltage.
Brushless motors often give more torque for their size, but not always. Here's why, when brushed motors keep up, and what sets torque in practice.
Yes. A transformer uses electromagnetic induction: AC in the primary coil creates a changing magnetic field that induces voltage in the secondary coil.
Forum and community sources put a 3300KV motor at roughly 10.5 to 13.5 turns, depending on brand. There is no exact formula, so check the spec sheet.
Most standard hobby servos turn about 180 degrees, and a few models differ. Continuous-rotation and multi-turn servos go further, with trade-offs.
Build a simple homopolar motor from a battery, a neodymium magnet, a steel screw and copper wire, and learn the Lorentz force behind the spin.
Connect a brushless motor's three wires to an ESC, wire the signal and power leads, reverse the direction by swapping two wires, and arm safely.
Wire an A4988 stepper driver to an Arduino, set the current limit safely, pick microstepping, and run a simple sketch that moves a NEMA 17 motor.
Learn how an H-bridge reverses a DC motor, how the L293D and L298N chips differ, and how to control both direction and speed from an Arduino.
Servo project ideas for beginners and makers, plus how to power servos safely and reverse a servo's direction in code or with continuous-rotation servos.
Learn how to wire 4-, 5-, 6- and 8-lead stepper motors, tell unipolar from bipolar, and find the coil pairs with a multimeter before connecting a driver.
A1 and A2 are a DC motor's armature terminals. S1 and S2 mark the series field winding, if there is one. Labels vary, so check the datasheet.
A DC motor's coil can create a high-voltage spike when switched off. A flyback diode across the motor protects the switch. Here's how to wire it.
Related topics