Electric Motors

How much can a servo motor turn?

Most standard hobby servos turn about 180 degrees, and a few models differ. Continuous-rotation and multi-turn servos go further, with trade-offs.

On this page
  1. Why most servos stop at about 180 degrees
  2. Continuous-rotation servos
  3. Multi-turn servos
  4. Can you modify a standard servo to turn further?
  5. How to check a servo’s range

Most standard hobby servos turn about 180 degrees. Some models cover a smaller or different range, so check the datasheet for your model. Two special types go further. Continuous-rotation servos spin without a stop, but they lose position control. Multi-turn servos can turn a few full rotations, with less precision.

Why most servos stop at about 180 degrees

A standard hobby servo reads its output angle with a potentiometer, and that sensor covers a limited arc. The gearbox also has mechanical end stops. The output cannot turn past the sensor’s range without risking damage. The control signal reflects this range. On most models, a pulse of about 1 ms to 2 ms maps to roughly 0 to 180 degrees.

Continuous-rotation servos

A continuous-rotation servo removes the position feedback. The control circuit still sees a fixed feedback value, so it keeps driving the motor. The control pulse now sets speed and direction, not an angle. Pulses shorter than the centre value turn the motor one way, and longer pulses turn it the other way. On many models, a pulse near 1.5 ms stops the motor. Models differ, and many have a trim pot to set the stop point.

A continuous-rotation servo does not hold an angle. You cannot ask it to go to 45 degrees. You can only set a speed and a direction. To know the position, you need your own feedback, such as timing or an encoder.

Multi-turn servos

Multi-turn servos use a geared feedback mechanism, so the output can turn several full rotations. They are less common and often cost more than standard servos. Because the feedback covers more rotation, each step of movement is less precise. A clutch usually protects the feedback, but if the output is forced past its limit, the servo can lose its absolute position.

Can you modify a standard servo to turn further?

Some standard servos can be modified for continuous rotation. The usual steps are:

  1. Remove the physical end stop on the output gear.
  2. Disconnect the feedback potentiometer from the output shaft. Keep the circuit fed with a fixed value, such as a pair of equal resistors, or keep the pot centred.

Results vary widely. Some gears cannot be modified, and some servos are damaged in the process. A modified servo loses its position control, and the warranty may be void. If you only need a full turn, a continuous-rotation servo or a small DC gear motor with an encoder may be a simpler route. For more on what to build with servos, see servo motor project ideas.

How to check a servo’s range

  • Check the datasheet for the rotation range.
  • Sweep the servo slowly from one end to the other with a test sketch.
  • Set the minimum and maximum angles in your code to the model’s safe range. Driving a standard servo past its stops can strip the gears or damage the potentiometer.
#include <Servo.h>
Servo myServo;

void setup() {
  myServo.attach(9);
}

void loop() {
  // Stay inside the model's range; 10 to 170 is a cautious start
  for (int angle = 10; angle <= 170; angle++) {
    myServo.write(angle);
    delay(15);
  }
  for (int angle = 170; angle >= 10; angle--) {
    myServo.write(angle);
    delay(15);
  }
}

If the servo buzzes or jerks at either end, back off the limits. That usually means it has reached its stop.

The complete guide to electric motors

Types of Electric Motors: DC, Servo and Stepper Compared
Read the guide

Keep exploring

Guides from other topics

All topics →