A DC power supply turns mains AC into steady DC for electronics. Compare linear, switching and variable supplies, learn the symbols, and see how each type fits your project.
Usually not: a higher voltage can damage a device, but a higher current rating is normally fine. USB-C negotiation and step-down converters change the answer.
Make plus and minus rails from one supply for audio and op amps. Compare center-tapped transformers, 7815/7915 regulators, charge pumps and virtual ground.
Read a wall adapter label: AC input, DC output volts and amps, polarity, watts and certification marks. Includes a worked example and replacement tips.
Set a bench supply's current limit safely: short the outputs, set the limit, then set the voltage. Learn what constant current mode means for your circuit.
Test a motherboard with a multimeter for shorts, a weak CMOS battery and missing power rails. Learn the safe order of checks and what a meter cannot prove.
No output from a power supply? Check the outlet, cable, fuse and output setting, then measure voltage. Step-by-step checks for wall adapters and bench units.
Switch-mode power supplies are efficient but have drawbacks: switching noise, complex circuits, load sensitivity and electrical hazards on the mains side.
A switch in a power system opens or closes a circuit to connect or cut off power. Learn the main types, from breakers to transistor switches in power supplies.