The short answer
There are four basic feedback connections. Each one is named by what it samples at the output and how it mixes the feedback signal at the input:
- Voltage-series feedback
- Voltage-shunt feedback
- Current-series feedback
- Current-shunt feedback
Voltage-series feedback is often preferred in voltage amplifiers because it raises input impedance and lowers output impedance, which are the two properties most voltage stages want.
How the names work
- Voltage or current describes what is sampled from the output. Voltage feedback senses the output voltage. Current feedback senses the output current, often through a resistor in the output path or an emitter resistor.
- Series or shunt describes how the feedback joins the input. Series means the feedback voltage is in series with the input source. Shunt means a feedback current is applied in parallel at the input node.
Voltage-series feedback
A fraction β of the output voltage is subtracted in series with the input, so the amplifier responds to V_in − βV_out. The closed-loop gain is:
A_f = A / (1 + Aβ)
The non-inverting op-amp amplifier is the classic example. Two resistors form a divider from the output to ground, and the midpoint drives the inverting input. That divider sets β = R1 / (R1 + Rf), where R1 goes to ground and Rf goes to the output. The closed-loop gain is 1 + Rf/R1, which equals 1/β.
The emitter follower is another example. Its output follows the input, so β = 1 and the gain is just under 1.
Voltage-shunt feedback
The output voltage is sampled, and a feedback current proportional to it is fed into the input node in parallel with the source. The inverting op-amp amplifier is the classic example. A feedback resistor Rf runs from the output to the inverting input, and the input resistor Rin also connects to that node. The closed-loop gain is approximately −Rf/Rin.
Because the feedback is shunt at the input, the input impedance is low. For an ideal op amp, the inverting node acts as a virtual ground.
Current-series feedback
The output current is sampled, and a voltage proportional to it is placed in series with the input. An unbypassed emitter resistor (RE) in a common-emitter stage is the everyday example. The AC emitter current develops a voltage across RE that opposes the base-emitter input signal.
This raises the input impedance and the output impedance. When the loop gain is large, the voltage gain approaches −RC/RE, where RC is the collector resistor. Removing the bypass capacitor across RE lowers gain but makes the stage more predictable.
Current-shunt feedback
The output current is sampled and fed back as a current in parallel with the input. The input impedance falls, and the output impedance rises. This type appears less often in beginner circuits, so it is the one to learn last.
Effect on input and output impedance
The impedance changes all come from the same factor, (1 + Aβ).
| Topology | Input impedance | Output impedance |
|---|---|---|
| Voltage-series | Increases | Decreases |
| Voltage-shunt | Decreases | Decreases |
| Current-series | Increases | Increases |
| Current-shunt | Decreases | Increases |
These are approximations. The actual change depends on which impedance you measure and on the amplifier’s internal details.
Choosing a topology
- A voltage source driving a light load usually wants voltage-series feedback, for high input impedance and low output impedance.
- If you need inverting gain and can accept a lower input impedance, a voltage-shunt stage such as the inverting op-amp amplifier works well.
- If the output should behave like a current source, or you need a current-controlled output, the current types are the ones to study.
For how these connections fit into the wider amplifier families and stability, see the feedback amplifier types guide. The op-amp gain formulas for the voltage-series and voltage-shunt cases are worked through in inverting and non-inverting op-amp gain.