Components and Schematics

Is power MOSFET and MOSFET the same?

A power MOSFET is a MOSFET built for higher current and voltage. Learn what stays the same, what changes in the ratings, and how to choose the right one.

On this page
  1. Yes, a power MOSFET is still a MOSFET
  2. What stays the same
  3. What changes: the ratings
  4. Small-signal and power examples
  5. N-channel and P-channel
  6. How to choose one

Yes, a power MOSFET is still a MOSFET

A power MOSFET is a metal-oxide-semiconductor field-effect transistor, the same device family as any other MOSFET. Its gate voltage controls a channel between the drain and the source. The word “power” describes how the device is built and rated. A power MOSFET is designed to carry more current, block higher voltage, and dissipate more heat than a small-signal MOSFET.

What stays the same

  • Operating principle: a gate voltage controls the channel.
  • Terminals: gate, drain, and source.
  • Gate: the gate is insulated, so it draws very little steady current.
  • Behavior in a circuit: both can switch a DC load on and off, and both can be driven from a logic-level signal if the device is chosen for it.

What changes: the ratings

Power MOSFETs are sold with a set of ratings that matter more than the name:

  • Drain-source voltage (V_DS): the maximum voltage the device can block. It should be above the highest voltage in the circuit, with some margin.
  • Continuous drain current (I_D): the current the device can carry at a stated case temperature. In a real circuit, heat often limits the current before this number is reached.
  • On-resistance (R_DS(on)): the resistance when the device is fully on. It sets the voltage drop and the heat loss at a given current.
  • Gate threshold and drive voltage: the gate voltage at which the device starts to conduct, and the gate voltage at which R_DS(on) is specified.
  • Package and thermal rating: a larger package with a metal tab sheds more heat, often with a heatsink attached.

Small-signal and power examples

To give a sense of scale, the small-signal N-channel 2N7000 is rated for about 200 mA continuous current. The IRF540N, a common power MOSFET, has a datasheet continuous current rating in the tens of amps, at a stated case temperature. Both are MOSFETs. The difference is the size of the device and its ratings, and the same datasheet approach works for both.

N-channel and P-channel

Both small-signal and power MOSFETs come in two polarities. An N-channel MOSFET conducts when its gate is positive relative to its source. A P-channel MOSFET conducts when its gate is negative relative to its source. Power switching often uses N-channel parts, because for a given size they often have a lower on-resistance. P-channel parts can be simpler for switching the positive side of a load.

How to choose one

  1. Find the highest voltage in your circuit and pick a V_DS rating with margin above it.
  2. Find the load current, pick a continuous current rating with margin, and then check the heat in the datasheet’s derating curve.
  3. Check R_DS(on) at the gate voltage your driver can actually supply.
  4. Pick a package that fits your heatsink or board area.

Our power transistor vs MOSFET article compares MOSFETs with bipolar power transistors, which is useful when you are deciding between the two types.

The complete guide to components and schematics

Electronic Components Explained: Active vs Passive
Read the guide

Keep exploring

Guides from other topics

All topics →