Components and Schematics

Do inductors pass direct current?

Yes, an inductor passes steady DC, limited mainly by its winding resistance. Learn what happens when DC is switched on and off, and why it can overheat.

On this page
  1. Short answer
  2. What happens the moment DC is applied
  3. How quickly it settles: the L/R time constant
  4. Switching DC off: the voltage spike
  5. Why an inductor can overheat on DC
  6. Where DC and inductors meet in practice

Short answer

Yes. Once the current settles, a steady DC current passes through an inductor, and only the inductor’s winding resistance limits it. An ideal inductor has no resistance, so in steady DC it behaves like a short circuit. A real inductor has a small DC resistance, often written DCR, and in a simple circuit the steady current is the supply voltage divided by that resistance.

What happens the moment DC is applied

Current through an inductor cannot change instantly. A changing current induces a voltage across the coil that opposes the change, which is called back EMF. When you first apply DC, the current starts at zero and rises over time. For a brief moment, the inductor resists the change, which is why it can look like an open circuit at the instant of switching.

How quickly it settles: the L/R time constant

In a simple series circuit of an inductor L and a resistor R, the current rises toward its final value along a curve set by the time constant, τ = L / R. After about five time constants, the current is within about 1% of its final value.

For example, a 10 mH inductor in series with 10 Ω has a time constant of 0.01 H / 10 Ω = 1 ms. After about 5 ms, the current has nearly reached its steady value.

Switching DC off: the voltage spike

When the DC source is removed, the magnetic field collapses, and the inductor tries to keep the current flowing. This can produce a large voltage spike across the coil, which can damage switches and transistors. A flyback diode placed across the coil gives the current a path to decay safely. Its cathode goes to the positive side of the supply, so the diode is reverse-biased during normal operation. Types of diodes covers suitable parts.

Relays and solenoids work this way. How a relay works explains the coil side in detail.

Why an inductor can overheat on DC

Because the steady current is set by the supply voltage divided by the winding resistance, a small inductor connected straight across a DC source can draw far more current than its rating. Check the rated DC current on the datasheet, and limit the current in the circuit if the source could exceed it. The heat comes from the winding resistance, with power loss given by I²R.

At high DC current, a magnetic core can also saturate. Its inductance then drops, so the part stops behaving as the nominal value on the datasheet. This is a common reason power inductors in DC circuits are rated for a maximum DC current as well as an inductance.

Where DC and inductors meet in practice

  • Power supplies: buck and boost converters store energy in an inductor and release it to step a voltage down or up.
  • Filters: an inductor passes DC while resisting changes in higher-frequency AC. Paired with capacitors, it smooths ripple.
  • Coils: relay and solenoid coils pass DC to build a magnetic field that moves a contact or a plunger.

For the three basic passive parts side by side, see the definitions of resistors, inductors, and capacitors. For the wider classification question, see active vs passive components.

The complete guide to components and schematics

Electronic Components Explained: Active vs Passive
Read the guide

Keep exploring

Guides from other topics

All topics →