A DC source is an element that supplies electrical energy with a constant polarity. Current flows in one direction, and the voltage across its terminals does not reverse. Batteries, solar cells and DC power supplies are common examples.
DC voltage source and DC current source
Circuit analysis uses two idealised types:
- A DC voltage source keeps a steady voltage across its terminals. An ideal one holds that voltage whatever current the load draws.
- A DC current source delivers a steady current. An ideal one delivers that current whatever voltage the load develops, within its limits.
Most real DC sources are closer to voltage sources. Batteries and DC power supplies are usually modeled that way.
Real sources have internal resistance
A real battery acts like an ideal voltage source in series with a small internal resistance. Under load, some of the voltage is lost across that resistance, so the terminal voltage falls.
For example, a 9 V battery with 0.5 Ω of internal resistance supplying 1 A has a terminal voltage of 9 V − (1 A × 0.5 Ω) = 8.5 V. The same battery supplying a smaller current has a terminal voltage closer to 9 V.
Common examples
- Batteries: from AA cells to lithium-ion packs and car batteries.
- Solar cells (photovoltaic cells): they produce DC when light falls on them.
- DC power supplies: bench supplies and the output of phone chargers, after conversion from mains AC.
- Fuel cells and DC generators (dynamos): they produce steady DC from a chemical reaction or from a turning shaft.
How to recognise DC on an oscilloscope
On an oscilloscope, a DC voltage appears as a flat line at a fixed level. An AC voltage appears as a wave that rises above and falls below zero.
Turning AC into DC
Mains power is AC. Most electronics that run from the wall use a converter to produce DC. The usual chain is a transformer, a rectifier that lets current flow in one direction, capacitors that smooth the pulses, and a regulator that holds the output steady. The result is a DC source, even though its input is AC. For the full chain, see Why Electronics Run on DC (and Why the Grid Uses AC).
Why it matters in circuit analysis
- Ideal DC sources are the building blocks of most textbook circuit problems, and they are the starting point for Kirchhoff’s laws and Thevenin’s theorem.
- With a steady DC source, a capacitor eventually stops passing current and acts as an open circuit, while an ideal inductor acts as a short. This is the basis of the RC circuit analysis method.
For the general picture of sources, see Circuit Analysis Basics.