Circuit Theory

Is US voltage AC or DC?

Is US voltage AC or DC? The US grid uses 60 Hz alternating current at a nominal 120 volts, with 240 volts for large appliances, and where DC still appears.

On this page
  1. What “nominal 120 V” means
  2. Why 60 Hz
  3. 120 V and 240 V split-phase
  4. Where DC still appears
  5. Why the grid uses AC
  6. Safety note

US household mains power is alternating current (AC). A standard wall outlet supplies a nominal 120 V RMS at 60 Hz. Many devices inside the house then convert that AC to DC.

What “nominal 120 V” means

“Nominal” is the design value. Utilities keep the supply within an allowed band around 120 V, so a meter reading can differ from 120 V by a few volts at any time.

Why 60 Hz

A frequency of 60 Hz means the voltage completes 60 cycles per second. Because each cycle has two polarity reversals, the voltage reverses direction 120 times per second. Many other countries use 230 V at 50 Hz.

120 V and 240 V split-phase

Typical US homes get a split-phase supply. Two 120 V legs are fed from the transformer, and their waveforms are 180° out of step with each other. Standard outlets connect to one leg and give 120 V. Between the two legs, the voltage is about 240 V.

Larger appliances, such as electric dryers, ovens and central air conditioners, usually use 240 V. The higher voltage lets them draw the same power at a lower current.

Where DC still appears

DC is common in the US too, even though the grid is AC:

  • Batteries and everything that runs on them, from TV remotes to electric cars.
  • Solar panels produce DC. An inverter converts it to AC for the house or the grid.
  • Electronics such as phones, laptops, TVs and LED lamps. Their power supplies convert AC to DC inside the device or in the wall adapter.
  • High-voltage DC (HVDC) lines carry power over long distances and under the sea in some installations.

For more on how AC becomes DC in electronics, see Why Electronics Run on DC (and Why the Grid Uses AC).

Why the grid uses AC

Transformers only work with AC. They can step the voltage up for long-distance transmission and back down for homes. For the same power, a higher voltage means a lower current. Lower current means less energy lost as heat in the lines, because the loss is I² × R.

This practical advantage was central to the late-19th-century “War of Currents” between Nikola Tesla’s AC systems and Thomas Edison’s DC systems. AC became the standard for power grids.

Safety note

Mains voltage can cause serious injury or death. Do not open mains wiring, outlets or appliances unless you are trained and qualified to do so. If in doubt, call a licensed electrician.

For the basics of sources, see What is a DC source? and Circuit Analysis Basics.

The complete guide to circuit theory

Circuit Analysis Basics: Voltage, Current and Sources
Read the guide

Keep exploring

Guides from other topics

All topics →