The short answer: 5 time constants
A capacitor is usually considered fully discharged after 5 time constants (5τ). After 5τ, about 0.7% of the starting voltage remains, which means the capacitor has lost more than 99% of its voltage.
The time constant is τ = R × C, in seconds when R is in ohms and C is in farads. See the RC time constant for the derivation.
The percentages after each time constant
When a charged capacitor discharges through a resistor, the voltage falls exponentially:
| Time | Voltage remaining |
|---|---|
| 1 τ | about 36.8% |
| 2 τ | about 13.5% |
| 3 τ | about 5.0% |
| 4 τ | about 1.8% |
| 5 τ | about 0.7% |
After 1τ, the capacitor has lost about 63% of its voltage. Each further time constant cuts the remaining voltage by a factor of about e, which is roughly 2.7.
Why “fully” is a convention
An exponential curve never reaches exactly zero. In theory, the voltage approaches zero asymptotically. In practice, engineers choose a cut-off point, and 5τ is the common choice because the remaining voltage is then well under 1%.
So “fully discharged” means “discharged to a level that is negligible for most circuits.” It does not mean the voltage is exactly zero. Some engineers use a different cut-off for a particular design, so check the requirement you are working to.
A worked example
Take a 1 kΩ resistor across a 1,000 µF capacitor.
- τ = 1,000 Ω × 0.001 F = 1 second
- 5τ = 5 seconds
After about 5 seconds, roughly 0.7% of the starting voltage is left. For a 25 V capacitor, that is about 0.2 V. The same calculation works for any resistor and capacitor pair.
Why 5τ is not a safety guarantee
The 5τ figure is an estimate from an ideal model. In a real circuit, several things can change the result:
- Component tolerance: the actual capacitance and resistance may differ from their marked values.
- Other paths: a leakage path, another resistor or a parallel load can speed up or slow down the discharge.
- Voltage rebound: a large capacitor can recover some voltage after the resistor is removed.
For any part that could hold a dangerous charge, measure the voltage with a meter before you touch it. See how to discharge a capacitor faster for the safe method, and how to test a capacitor with a multimeter for measuring.
Key takeaways
- A capacitor is usually considered fully discharged after 5τ, when about 0.7% of the starting voltage remains.
- The exponential never reaches zero, so “fully” is a practical cut-off.
- τ = R × C. A 1 kΩ and 1,000 µF pair gives τ = 1 s and about 5 s to 5τ.
- The 5τ rule is a model, not a safety guarantee. Measure the voltage before handling.