Capacitors

Supercapacitors Explained: Uses, Limits and How They Differ From Batteries

What supercapacitors are used for, their limits such as low energy density and falling voltage, and how they differ from batteries in charge and cycle life.

On this page
  1. What a supercapacitor is
  2. What supercapacitors are used for
  3. Limits: low energy density and falling voltage
  4. How supercapacitors differ from batteries
  5. Choosing one: the questions to ask
  6. Key takeaways

What a supercapacitor is

A supercapacitor, also called an ultracapacitor or electric double-layer capacitor (EDLC), is a capacitor with a very large capacitance for its size. Its capacitance is measured in farads, sometimes in hundreds or thousands of farads in a single package.

It stores charge differently from a battery. Charge builds up in a thin layer at the surface of porous electrodes, and ions from the electrolyte line up against it. Nothing is chemically changed, which is why supercapacitors charge quickly and tolerate many cycles. A battery stores energy in chemical reactions, which is slower and wears the battery out over time.

Each cell works at a low voltage. Common organic-electrolyte cells are rated at about 2.5 to 2.7 V. Higher voltages need several cells in series, with balancing, as discussed below.

What supercapacitors are used for

Supercapacitors excel where you need a lot of power quickly, or many charge cycles, rather than a lot of stored energy.

Memory and backup

Supercapacitors can hold a memory chip, real-time clock or small controller up during a brief power interruption, so settings are not lost. They can also allow a device to shut down safely when power drops. Because they can be charged quickly, they are often chosen over a rechargeable battery for short backup periods.

Peak current and battery support

A supercapacitor placed in parallel with a battery can supply short bursts of high current, such as a motor start or a radio transmission. The battery then supplies the average load, and its life is extended because it does not deliver the peaks. This is sometimes called load leveling.

Regenerative braking and transport

Buses, trams and some hybrid vehicles use supercapacitors to capture energy during braking and release it on the next acceleration. The fast charge and many cycles suit this stop-start duty.

Energy harvesting and pulse power

Small sources, such as light or vibration harvesters, can charge a supercapacitor slowly. The stored energy can then be released in short pulses, for example for a wireless transmission.

Limits: low energy density and falling voltage

Energy density

Supercapacitors hold far less energy per kilogram than batteries. A typical EDLC has an energy density in the range of about 1 to 10 watt-hours per kilogram. Lithium-ion batteries hold much more. A supercapacitor is therefore a poor choice for running a device for hours.

Voltage falls as the charge falls

A capacitor’s voltage is proportional to its charge, so its voltage falls steadily as it discharges. A battery holds a roughly steady voltage for most of its life. That matters because most circuits need a minimum voltage to work, and a supercapacitor’s stored energy below that minimum is not usable without a converter.

Energy stored is E = ½ × C × V². The energy you can actually use is the difference between the energy at full voltage and the energy at the minimum voltage your circuit needs.

A worked example of usable energy

Take a 1 F cell charged to 2.7 V. It stores about 3.6 J (½ × 1 × 2.7² ≈ 3.6).

  • If the circuit needs at least 1.35 V, about 2.7 J is usable, roughly 75% of the stored energy.
  • If the circuit needs at least 2.0 V, about 1.6 J is usable, roughly 45%.

The lower the minimum voltage, the more of the stored energy you can use. A DC-to-DC converter can help, but it adds cost and losses.

Voltage per cell and balancing in stacks

To reach a higher voltage, supercapacitors are connected in series. Cells in a series stack must be balanced, usually with resistors or an active balancing circuit, so no single cell is pushed above its rated voltage. Without balancing, one weak cell can overcharge while the others are still charging. Most EDLCs are also polarized, so reversing the connection can damage them.

Self-discharge

Supercapacitors lose charge over time, and the loss can be significant compared with some batteries. The rate depends on the cell, the electrolyte and the temperature. Check the datasheet’s leakage or self-discharge figure, rather than relying on a general statement.

How supercapacitors differ from batteries

Feature Supercapacitor Battery
How it stores energy Electrostatically, at the electrode surface Chemically
Energy per kilogram Low, a few watt-hours per kilogram Much higher
Charge time Seconds to minutes Minutes to hours
Power delivery Very high, in short bursts Lower, sustained
Cycle life Very many cycles Fewer cycles, which wear out with use
Voltage during discharge Falls steadily Roughly steady for much of its life
Self-discharge Can be significant Varies by chemistry
Polarity Usually polarized Polarized

These are general comparisons, and figures vary by product. Always check the datasheet.

Choosing one: the questions to ask

  • How much energy, and for how long? A supercapacitor suits short bursts, not long runtimes.
  • What is the minimum voltage the circuit needs? This sets the usable energy.
  • How often will it cycle? Frequent charge and discharge favors a supercapacitor.
  • How long must it hold charge? Check self-discharge if the device sits idle for days or weeks.
  • What voltage will the stack run at? Plan balancing and check the cell rating.

Key takeaways

  • Supercapacitors store charge electrostatically, so they charge quickly and last through many cycles.
  • They suit backup, peak current, regenerative braking and energy harvesting.
  • Their energy density is low, and their voltage falls as they discharge, so usable energy depends on the minimum voltage.
  • Series stacks need balancing, and most supercapacitors are polarized.
  • Self-discharge can be significant, so check the datasheet for the part you plan to use.
  • A charged supercapacitor stack can store significant energy. Discharge it before you work on it.

For the broader picture of how the largest capacitors compare, see capacitors explained. Leakage behavior in general is covered in capacitor leakage current.

The complete guide to capacitors

Capacitors Explained: How They Behave in DC and AC Circuits
Read the guide

Keep exploring

Guides from other topics

All topics →