What a flash capacitor does
A camera flash needs a short, intense burst of light. The flash capacitor stores the energy for that burst, and it releases the energy through the flash tube in a few milliseconds. The battery alone cannot supply that burst quickly enough, so the capacitor acts as a local energy store between the battery and the tube.
How it charges
The battery powers a small DC-to-DC converter, which steps the battery voltage up to a much higher voltage. In many flashes this is a transformer-based circuit that switches on and off many times a second. Each cycle pushes a little more charge into the flash capacitor, through a diode that stops it from flowing back.
The capacitor voltage rises until it reaches the level the flash needs. A “ready” light, often a neon lamp or an LED, shows when the charge is high enough. Charging typically takes a few seconds, depending on the battery and the flash.
When the flash fires, a trigger circuit allows the stored energy to pass through the tube. The capacitor then discharges and the converter starts to recharge it.
Why it stays charged after switch-off
Turning the camera or flash off does not remove the charge from the capacitor. Removing the batteries does not either. A flash capacitor can stay dangerously charged for a long time after the power is removed, unless the circuit has a working discharge path.
Some designs include a bleeder resistor, but you should not rely on one. A flash that has been switched off, or a flash with a damaged circuit, may still hold a high voltage.
Why a small capacitor can still be dangerous
Flash capacitors often store only a few joules of energy, which can seem small. But the voltage is what makes them dangerous. A capacitor charged to a few hundred volts can deliver a painful shock, and it can cause injury even when it is small.
Voltage matters more than capacitance
The energy stored in a capacitor is E = ½ × C × V², so doubling the voltage quadruples the energy. Here is an example:
- 100 µF charged to 300 V stores ½ × 100 × 10⁻⁶ × 300² = 4.5 J.
The same capacitor at 150 V stores only about 1.1 J. Voltage makes the difference, which is why a flash at a few hundred volts should be treated with respect.
Studio strobes and other large flash units store much more energy and are more dangerous still. Treat them the same way, or more cautiously.
What to do instead of opening a flash
- Do not open the flash. The high-voltage parts are hazardous, even if the flash looks switched off.
- Do not try to discharge the capacitor with a screwdriver or any improvised short. The discharge can spark, damage the parts and cause injury.
- Do not handle the capacitor terminals with bare hands, and do not assume a capacitor is safe because the battery is out.
- Take the flash to a qualified repairer if it is broken, or if you need the capacitor removed or replaced.
- Dispose of it through a proper electronics recycling route if it cannot be repaired, and say that it may hold charge.
For the general principles of discharging a capacitor safely, see how to discharge a capacitor faster. For a high-voltage part, the first step is to get professional help rather than to work on it yourself.
Key takeaways
- A flash capacitor stores energy from a converter that steps up the battery voltage, often to a few hundred volts.
- It can stay charged after the flash is switched off or the batteries are removed.
- Energy depends on voltage squared, so a few hundred volts can give a dangerous shock even from a small part.
- Do not open a flash, and do not try to discharge it with an improvised short. Take it to a qualified repairer.
- Capacitors in high-voltage equipment deserve the same care as mains equipment.
For how capacitors store energy in general, see capacitors explained. For replacement limits on voltage ratings, see capacitor replacement guide.